-
### Modpack
FTB Revelation
### Modpack version
3.7.0
### Has the pack been modified
Yes
### Log Files
_No response_
### Describe the bug
So 3.7.0 is a dumpster fire from wha…
-
In the current board layout, the WiFi reset button is connected to the ESP8266 GPIO 16 on one side, and through a 10k ohm resistor to GND on the other. The ESP8266 [supports](https://arduino-esp8266.r…
-
## LPC1769 Modules Used in the Project
For this project, the following modules of the LPC1769 board will be used:
1. **GPIO**: Will be used to connect a 7-segment display, which will show the co…
-
I was looking at tools which interface with Yosys and came across your hardcaml-yosys project. However I was not easily able to understand what hardcaml is or why you would want to generate a netlist …
-
Hello @noorkhokhar99 ,
Can you please share the circuit diagram?
or can you please tell me if you used the digital or the analog pin for NH3, NO2 and CO pin?
When I went through the code, all the…
-
My Genie CM7600IC works well in dry contact control mode for door control and status (the obstruction sensors are too high voltage and aren't connected). However, the Genie wall control keypads have l…
-
**
### Synthetic circuits integrating logic and memory in living cells
Piro Siuti, John Yazbek & Timothy K Lu (2013)
**
**Global summary:**
- Strategy for building synthetic logic circu…
-
Some [SNDH](http://sndh.atari.org/) files made for the [Atari STE](https://en.wikipedia.org/wiki/Atari_ST#STE_models) make use of the [LMC1992](https://www.farnell.com/datasheets/33122.pdf) circuit fo…
-
**First observation of cell to cell communication:**
Due to challenges such as molecular cross-talk, no more than two communication systems have been combined in a single design until now (2020).
…
-
Miriam was designed to be simple and inexpensive. As far as this affects the photodiode circuit, we could investigate several things to achieve higher sensitivity and lower noise:
- investigate alt…