-
Create new pick and place files for Rev D1 specialized for PCB:NG's needs.
-
KiCad provides a CSV output for the BOM but it needs to be updated to the latest changes. This should not be affected by panelization.
-
Simply Looking at the board to see if everything makes sense. Very 10k foot view stuff.
-
**Proxy.py:** [https://github.com/FaradayRF/Faraday-Software/blob/master/proxy/proxy.py](https://github.com/FaradayRF/Faraday-Software/blob/master/proxy/proxy.py)
While writing the device configura…
-
Re-test #14 with code that sends lots of RF data to verify.
-
Move proxy code over from SVN into GitHub. In doing so, clean up the code and simplify it according the the current understanding of the software architecture using POST and GET responses to localhost…
-
Testing performed to validate the design of the 5V USB power supply inrush limiting and USB compliance. Essentially, it's in our best interest to prevent Faraday from causing an inrush event when plug…
-
As discovered in https://github.com/FaradayRF/Faraday-Firmware/issues/52 the program sent un-encoded data through the network interface and this cause framing errors (Start Byte) during some configura…
-
Check Rev C Gerbers against Rev B Gerbers to make sure any and all differences are accounted for. The quickest way to do this is to use GerbV to XOR Rev B and Rev C, leaving the differences highlighte…