-
hi Tom,
I know your design is just a tester board. But Sparkfun used to sell a clone of the ByteBlasterMV programmer (http://www.sparkfun.com/datasheets/DevTools/FPGA/Altera%20Programmer/Altera_…
-
Hello,
any hint is appreciated, I'm kind of desperate!
I'm using latest Arduino IDE 1.8.19 under up-to-date Win10 64-Bit and set up everything exactly as described in Readme. This is a fresh ins…
-
Hi in the "Verify Installation" section of the book openocd is started with the interface/stlink.cfg or the /stlink-v2.cfg new boards use a stlink-v2-1 so the correct file is the interface/stlink-v2-1…
-
Following the guide:https://github.com/pulp-platform/pulpissimo/blob/master/rtl/tb/README.md, I tried the OpenOCD to connect the RTL platform and get the errors below.
on RTL platform side, continuou…
-
### Description
I just updated to 24.1 and was unable to start with my old config:
`EBUSD_OPTS="--scanconfig -d ens:/dev/serial/by-id/usb-Espressif_USB_JTAG_serial_debug_unit_xx:xx:xx:xx:xx:xx-if0…
-
I built the acorn.py for both the CLE-215 and the Alientek board,
and I get in both cases the same symptoms:
```
$ litex_server --jtag --jtag-config ft232.cfg
Open On-Chip Debugger 0.12.0
Lice…
-
It seems that commands 0x80-0x83 not usable
-
**Is your feature request related to a problem? Please describe.**
No, only requesting to add a new supported chip
**Describe the solution you'd like**
Support CC1352R
**Describe alternatives…
-
Hey everyone,
I'm taking a go at investigating the Smart Probe that was referenced in issue #5. I have managed to make some advancements on the SW side, but I'm at a point where I'd need some more …
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have up…
vdm97 updated
1 month ago