-
**Is your feature request related to a problem? Please describe.**
I always use support z-distances of between 0.1 and 0.15mm, I should be able to make a 0.3mm layer height print with supports that s…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
When probing with the BL-Touch, installed in the z-endstop pin on the BTT E3V3 board, t…
-
### See latest post at bottom for better summary and narrowed down bug in stepper.h and stepper.cpp.
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### …
-
## Current Behavior
I recently purchased a Matek F405-wing V2 and I am unable to get CRSF/ELRS telemetry working. The RX channels works. The only telemetry back to the radio (TS16S) if the receiver t…
-
If I have a print going, and my desktop's power manager kicks in to blank the screens, Cura starts stalling out while sending data to the printer, causing the printer to hang and stall and otherwise…
-
Hi! Great work.
I followed the instructions as mentioned in the readme on wikitabletext data, and wasn't able to replicate the results. I trained a HAD model, and ran inference using the test_const…
-
{noformat}Defining a Deep Learning Model
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
H2O Deep Learning models have many input parameters, many of which are only accessible via the expert mode. For most cases, use…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
I use a removable probe under the nozzle and when starting delta calibration, the head takes …
-
I was attempting to use sarracen to re-create some figures from https://arxiv.org/abs/2106.05281 as part of my JOSS review and I am running into some issues with the 'exact' backend.
The following …
-
I am following the instructions for building the docker container but my build is failing. The error thrown is the following:
```
[+] Building 14371.8s (12/22) …