-
Think you could add a nice effect to the globals to handle Kineticist Kinetic Aura?
-
I have been attempting to run some 4 component DHF calculations in Pyscf:
I set up the calculation of h2o in the 3-21g basis and found the DHF SCF Energy: -75.6270551569308 Hartree
I tried setti…
-
# What?
Reduce the AMS damage (and grid damage if they have that) and BP cost of all Kinetic PD turrets ( Heimdall, Painless, Bainless) concurrently and by the same relative ammount (roughly half). F…
-
I'm not sure of the cause, but I've been running into an apparent memory leak (which has crashed my laptop a couple of times due to running out of memory), when running a kinetic electron simulation o…
-
New BRAVE weaponry entering loot pool - add to wishlist now to avoid future pain
https://d2foundry.gg/w/568611922?p=0,0,0,0&m=0&mw=0
-
Kinda annoying and cannot disable it. Also useless to me since you can just zoom in and out on place you need.
UPD: Probably what I meant was that smooth view pan gives you acceleration, which you …
-
Hi, Dr. Alivaziri, the kinetic model you used in the program doesn't match the one in the paper, I have a question about that.
_Kapa = atan(0.5*tan(u(2)));_ what is kappa? Thanks.
-
Greetings,
At the time I used this package with 14.04, Indigo and upstart, there was no issue getting a full log of every node in real time by using` tail -f ` on the myjob.log file.
However, …
-
`catkin_make` shows the following error:
-
Here https://github.com/cp2k/cp2k/blob/master/src/input_cp2k_motion_print.F#L110
and (vice versa) here: https://manual.cp2k.org/trunk/CP2K_INPUT/MOTION/PRINT/VELOCITIES.html,
it is stated that "Havi…