-
#### Issue details
I just installed 1.3.49 release and have the problem that I can't update my Pixhawk 2.1 anymore. It simply won't detect and recognize the board at the beginning of the update.
Ot…
-
**Describe the bug**
Inverted UART does not work. Is not inverted. I tried to make FRsky telemetry (S.port) work. And I was unable to get in working. After some time, I looked at it with an oscillosc…
-
**Issue details**
KDECAN doesn't appear to be working on ArduCopter firmware 4.3.0 and above. We've had quite a few customers complain about this who are excited to use the new firmware but can't bec…
-
### Describe the bug
Using the pixhawk 6x with both power ports used.
On both power ports there is an power module (PM). One Power port has an INA226 and the other has an INA228.
Both work on their…
-
### Describe the bug
I have QGC `4.2.8` (also tried the daily build), and Pixhaw 6X.
I tried to install the latest stable PX4 `v1.14.0`. However the reported version after installation is `v1.13.3`
…
-
I'm working on a project where it's useful to be able to control the drone from both dronekit and the remote controller (e.g., I'm running a script using the Python API, but want to make small adjustm…
-
### Describe the bug
I install the 1.14 stable version of PX4 into my Pixhawk 6x model on my rover. The parameters are ok, however, I cannot control my car via my RC or the sticks on the main scr…
-
Hi guys
Recently I have an issue with my flight controller. I can see on the Qgroundcontrol that GPS recognizes many satellites for instance 10 or more, although Pixhawk seems cannot sense it so it…
-
The parameters from connected UAVCAN nodes should each appear under a different heading per node.
Instead it's all mishmashed under Default Parameters and impossible to use.
@pavel-kirienko will b…
-
#### Issue details
Pixhawk buzzer volume is too low to be heard when looking for lost model.
Products providing load beeping capabilities exist and can be classified as follows:
1. Simple two wire …
Saxin updated
4 years ago