-
In your readme you allude to lathe main board (speed controller) failure associated with a short to the case from the control panel. I was, therefore, very careful never to run the lathe when the pan…
-
I have encountered the following error. I am not sure if the error is raised because I haven’t placed a library at the required location. Actually, I didn’t move/copy any library files, because (as I …
-
- run sim/axis-lathe, enable and home
- go to mdi, type
- g7
- g0x1
- (DEBUG,#)
- g8
- (DEBUG,#)
in both cases x is 0.5. the docs say: "Return current relative X coordinate including all offs…
-
23 growth not 24, 24 growth gonna spread weeds to nearby crops
If I'm in LV and wanting to get crops, what's the best way to get these crops? Is the Ztone garden soil good in this case?
ThorpianTo…
-
I come to you because I want to know the different parameters that must be set in the code and what are the different settings for in the photo below. For example:
SCREW_X (42) ??
MOTOR_X_STEP_P…
-
For implementing spindle sync for further drivers.
-
Please only submit bugs for the **latest** version of the code. You can check the version number in the startup messages.
**Do not add the bug label**. The developers of this repo will do that afte…
-
It may be good to be able to turn on the probe ISR and to halt on probe contact when you are moving around to do things like probe corners. probe_state_monitor seems to only be on during a probe. Yo…
-
I have completed the zh_ch.lang file. Do you need it?
-
Hi,
thanks for the list of supported MCUs. But I'm missing one information: the maximum clock (step) frequency one can achieve with them for the different axes (especially with the SAMD21 at 48 and…