-
My mini CNC mill has been working great with Remora firmware running on a Bigtreetech SKR V1.4 with TMC2209 drivers. The host is a Raspberry pi 4 Model B. Optional serial debug interface is also conne…
-
I am trying to drive a nema23/56 stepper with a TMC2660 on the TMC2660-BOB breakout board, with an arduino mega 2560. I'm attempting to run hardware SPI on the mega SPI pins (50 (MISO), 51 (MOSI), 52 …
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…
-
### Controller Board
esp32-s3-wroom DevKitC-1
### Machine Description
TMC2208 pen controller
### Input Circuits
_No response_
### Configuration file
```yaml
name: "TMC2209 ZenXY"
b…
-
Hello..
I have a strange issue..
When i connect the skr 1.3 via USB the PC detects and the microSD appears and everything works ok...
When i connect 24v i loose comunication with the pc...
But..
…
-
Hi,
I am currently working on a sand table (similar to the sisyphus table) but I am a bit lost when it comes to setting up the machine in Grbl. While I've done some Arduinos projects and worked wit…
-
Hi all
First one... sorry for bad english:)
My printer is made from
SKR 1.3
XYZ - TMC2208 UART
E - A4988
BLTOUCH
TFT24 v1.1
Marlin Version 2.0.5.3
I have got some issues with configurat…
-
Ive got a strange issue with a new printer im settting up. i have a set of tmc2209's, on a 24v corexy.
the original 1.8* motors are louder than they should be, but i didnt think much of it. this w…
-
Hello ZoetropeLabs,
I tried using this library with my as5048a, and normally if anything doesn't work properly I would assume it was my mistake at some point. However, I tried the same connection w…
-
Hello Guys
I have build a new Titan Aero on my Ender.
Using TMC2209 in Uart mode
E silentmode off
Old setup was with bowden and all prints where great, switch to titan aero and Retraction don't …