-
Is it possible to provide a configuration option to allow for a configurable trigger width?
I'm asking because I've ordered a bunch of JSN-SR04T rev 2.0 boards (which are prevalent in the market) w…
-
Hi, I need to use a HC-SR04 ultrasonic sensor on Turtlebot3 with ROS. The problem is that the sensor_state node reads sonar distance as 0 constantly. Upon further inspection, I noticed that sensor_sta…
-
### PROBLEM DESCRIPTION
If you set FIRMWARE_LITE flag you are not able to enable USE_MQTT_TLS option but only editing tasmota_configurations.h
### REQUESTED INFORMATION
_Make sure your have…
soosp updated
3 years ago
-
ESPHome: v1.15.3
Platform: ESP32
Board: esp32doit-devkit-v1
Installation on Raspberry Pi 4 (4Gb), ESPHome installed as docker container (no relation to my home-assistant install).
Affected c…
-
I'm looking for any detailed information of the bot shown at 17:40 of the YouTube video of [Peter Schmidt's Feb 13, 2019 presentation "Visual navigation for wheeled autonomous robots – using Intel® Re…
-
**Pybricks 1.0 was all about bringing Pybricks MicroPython to EV3.**
This came out early 2019. It's super exciting to see people using this actively.
An epic number of users! According to [Visua…
-
While testing the Kitronik MOVE Motor ultrasonic measuring block, it has been noticed that there has been a change from V1 hardware to V2.
For the V1 hardware, to make the ultrasonic sensor read …
-
I followed the example of HC-SR04 and tried the official drivers package.
But no matter what I do it always reads 0mm.
What am I doing wrong and which additional information can I provide?
``…
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
Connecting ultrasonic range sensor HC-SR04 or HC-SR04T 2.0 shows data and correct distance. When distance is g…
-
#### The Technology
* The Ultrasonic Sensor [model: HC-SR04] has a transmitter and a receiver
* Ultrasonic sensors work like radar: they emit an ultrasonic pulse and wait for it to _"bounce"_ of…