-
Hi, awesome to see this!
Can you please provide more info such as a wiring diagram, ESPhome code, supported heaters etc.
Thanks!
-
We repeatedly get questions about our calculations for transport demand. It would be efficient to write this down once properly and then be able to refer people to our documentation.
The main quest…
-
-
From j1939-84 created by [ericthomasswenson](https://github.com/ericthomasswenson): Equipment-and-Tool-Institute/j1939-84#1098
Improve status bit outcomes for DM5 and DM26.
In particular, modify…
-
Hello,
Just trying your custom component on my diesel heater but gettin below errors:
```
INFO ESPHome 2023.11.4
INFO Reading configuration /config/esphome/esp32-ble03.yaml...
INFO Detected t…
-
I have made an hardware, now what?
How can I get firmware for esp32?
How can I then controll it via mobile phone? How to connect to it?
-
This is a list of composed reports
composed report | label | definition | axiom
-- | -- | -- | --
Climate scenario report | | |
Economic scenario report | | |
greenhouse gas emis…
-
Engine sent busy, yet 2nd DM11 was not not observed in log.
11:57:23.0553 Global DM11 Request
11:57:23.0583 18EAFFF9 [3] D3 FE 00 (TX)
11:57:23.0609 18E8FF13 [8] 00 00 FF FF FF D3 FE 00
Acknowle…
-
Hi,
I like the idea, but in my case it is not working. Not pairing.
Is there a way to debug or get some help.
I have a LOLIN32 and C1101 and spi connection is good also the requeired parking hea…
-
In colder climates the printer (MK3) powers up and goes to error min bed temp. After heating the bed with a hot air gun it clears to hot end min temp and after a little heating so does the hot end. I…