-
I am brand new to this and I purchased a ANET A8 that was DOA. I purchased a mks gen 1.4 board and a mks mini12864 v1.0 & a mks tft32 w/ wifi. (I am not a coder/programmer)
I was able to get the mi…
rnx22 updated
2 years ago
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…
-
Just power off both heater and bed :(((
Two different (mirrored) pcs at the same heigh.
Hardware: DUE+RAMPS-FD+LV8729 (XY) 8825 (Z+E)
Repetier, Marlin 2.0 works well
`/**
* MK4duo Firm…
-
I made a post in the main branch of [Marlin](https://github.com/MarlinFirmware/Marlin/issues/22996) & another user [here](https://github.com/bigtreetech/SKR-2/issues/96) has a similar issue.
What I…
-
I'll try my best to explain this, the beta firmware you've provided, unless I've missed something, doesn't have the BigTreeTech 32 bit SKR V2.0 board, so I had to download the newest 2.0.9.2 marlin fi…
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
I try to send a file (a g-code) using web ui, but it is not able to write sd card (trying with differents sd card)....transfert is shown completed (100%), but no files are on the media, althought I ca…
-
Hi, Using 4.3.9 Configured with the online configurator. Have 2 nozzles set up by adding the following to configuration_overall.h
#define SWITCHING_NOZZLE
#if ENABLED(SWITCHING_NOZZLE)
#de…
-
all three marlin tango revisions seem to be the same 1.1.8 and seem to be setup for a delta.. i'm fairly new to marlin, and i am trying to get my new board running on a cartesian, and currently i am g…