-
Hi, i have issue again when read multipack battery.
Here this log
> 2024-08-11 17:15:34,343 - ha_mqtt - INFO - Connected to MQTT broker successfully
> 2024-08-11 17:15:34,346 - bms_comm - INFO - …
-
hello, thank you kindly for this code and explanation.
I have a unitree A1 motor and an rs485 to usb adapter with output of GND, A+, B-.
could you tell me the pinout of the rs485 input on the driver…
-
Hi,
Is there any plan of supporting growatt MOD series? It's RS485 based
-
### Describe problem solved by the proposed feature
RTT serial supports RS485 like linux RS485
### Describe your preferred solution
_No response_
### Describe possible alternatives
_No response_
-
Hi, thank you for your great project and support!
I'm a Software Engineer, and I have a JK BMS (PB-2A16S15P - HW: 15.XA, SW: 15.10) with a faulty RS485-1 (right besides CAN port), which makes me unab…
-
This is relatively simple, just need to add the correct architecture pins for the Hardware Serial1 to the architectures in RS432.h
I'm not sure you want the default TX pin to be 1 however, so you m…
-
### Describe the bug
I am having a setup with 6 EG4 lifepower batteries. They are dipswitched 1 till 6 (verified via BMS Test program).
Only the batteries 1, 3 and 5 are successfully read by dbus-…
-
Hello,
thank you for your library! I try to get it work, to connect to a Pylontech US3000C.
My setup:
OrangePi One with Armbian
Python 3.11
China USB to RS485 device (tried out several types)…
-
A galvanic TTL to RS485 device (Waveshare) is connected to T-POE-PRO (NOT opto-isolated) with a shielded cable.("2 wires + Ground + shield").
Where to connect signal RS485 ground and shield ground (M…
-
### Is your feature request related to a problem? Please describe.
Currently threre is CANbus Support for Pylontech & other Batteries
The information CAN provides is good but limited compared to the…