-
Hi,
Sorry for the beginner level question, but is there a parts list? I'm new to SMD and I'm having trouble figuring out what size capacitors and diode to order. The resistor sizes I read off the r…
-
Hello,
I've found no way to get this board working with dual Z driver and dual Z endstop.
The second Z driver (Z2) was recognized, but the endstop resource never be used.
My actual configuration …
-
While the DIAG1 on X and Y axis can be used for sensorless homing, there I found additional usage of the stallGuard for E axis. It can be connected to filament sensor pin, to trigger the M600 when the…
-
I want to connect 2 TMC2209 to arduino ,
when i send 1 in serial just one stepper worked wich have address 0b00 the otherone with ADD 0b11 not worked , however MS1 MS2 with Vio for Add 0b11
this…
-
Hi teemuatlut, you did a great job with this library!
I am having a little problem that I can't solve with your documentation (certainly because I am not much of a programmer)
I want to swap old A49…
-
**Please, follow this template when opening a new issue: this will help us a lot in the process of helping you.**
### Issue description
My sd card is plugged in before I run the printer, but it …
-
Since the SuperLongBoard is not yet available in Web Builder, I'm trying to build firmware for the LongBoard32, but I can't seem to get it working, and I keep encountering errors.
So far, I have cr…
-
I'm using a variant of the "Stallguard" example to tune the stallguard settings of my TMC 2130 SPI driver (from BigTreeTech), but I am having an SPI issue where the value for drv_status.sg_result retu…
-
### Is your feature request related to a problem? Please describe.
Actually I have dual Z drivers and invidual Max Z homing sensors. On Lerdge original firmware it's possible using the Ex-Axis functi…
-
I'm looking at getting a few of these made for sure, for my current printer, and was pricing it out.
At the current dimensions, 125 * 40mm I'm looking at 36 USD on easy EDA for 5 boards. That's 7.2…