-
### Bug Description
This is `bugfix-2.0.x` commit d84aff701e10a49d5ccc69ce323fdb0fdb84b6db
Long travels exhibit stuttering movement when ABL is configured and enabled.
If I switch ABL off by …
-
Several people (of which I am one) have reported issues with recent Klipper versions and SPI communication with the TMC5160 on the SHT36 Pro. Initially, when I used a mid-September 2023 version of Kli…
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
Hi there i am new to all this programming stuff i have a mks sgen v1 with tmc2209 on x, y, z, e1, axis and lv8729 on e0 i am trying to get sensor less homeing to work and dual z motors z, e1
i am…
-
Hi Terjeio, I'm trying to use GrblHal on a SKR3-EZ board with 5160 drivers (4 axis). I had some problems with USB communication, but @Dresco helped me and solved it. Now I'm having problems with Trin…
-
Hello,
I have SKR3 EZ board with old TMC2209 drivers that should be compatible. However, I am getting:
```
Driver registers: …
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
Was just taking a closer look at driver_setup(), with respect to the stepper enable pins & startup current draw in the Trinamic drivers..
I'd updated the [H7 driver](https://github.com/dresco/STM32…
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…