-
Hello,
I can not run a calibration with Marlin-1.1.0 RC7 (1.0.xxx OK) and Scara kinematic
I made a `G28`
then `M360` to move Theta 0 ° position
a look back `M114` (SCARA Cal - Theta: -17.82)
a …
-
Update to RC6, everything uploaded fine, it just won't connect. Tried Repetier Host and Octoprint.
Appears to be a Marlin-specific issue, if I install Repetier Firmware, I am able to connect without…
ghost updated
2 years ago
-
I need to get an accurate (
-
Hello. After G29 command not working raise between probing points. I don't understand why or what wrong I do?
Marlin 1.1.0-RC7
This is my configuration.h:
``` cpp
#include
/**
* Marlin 3D Pr…
-
I got serious pairing issues with various Zigbee 3.0 end devices. Sonoff Zigbee3.0 USB Dongle was using
{"maintrel":1,"majorrel":2,"minorrel":7,"product":1,"revision":20210120,"transportrev":2},"typ…
-
Any bump in my nozzle based z-min probe that closes the switch causes the layers of my prints to shift. Manually triggering the switch reliably reproduces the issue. Confirmed that this is an issue on…
-
Hi, sorry to raise this problem but I have spent more hours than I care to admit in trying to understand the problem using various sources including these forums.
Using Marlin V. 1.1.0 RC7 I have s…
-
OK all Anyone have any ideas on what is going on. I have been working on getting a BLtouch working for about a week now and I haven't been able to get it working yet. i finally today got it to move up…
-
After upgrade from RC5 to RC6 after each layer, all layer step by XY coordinate
-
So I recently built a Pegasus 12 by Makerfarm and decided to install Auto Bed Leveling using a micro switch and servo. I downloaded the current version of Marlin and have been editing ever since. Ho…