-
S.Port (and Passthrough) Telemetry via FrSky RX still works fine with ArduPlane firmware 3.94. Starting with firmware 3.95 incl. the “Latest” firmware GPS positions are only transmitted irregularly. T…
-
### Bug report
**Issue details
All rc failsafes, and throttle failsafe do not function. Throttle apparently is forced to neutral internally on SBUS RC failsafe and/or throttle failsafe since veh…
-
Hi ,
I am using ubuntu 16.04 with ROS Kinect.
I am trying to use the new Dynamixel XL430,
when I run roslaunch my_dynamixel_workbench_tutorial position_control.launch
I get this error :
`…
-
Hello world,
I use following config:
- RPi3 + Navio2
- PX4-emlid-navio2 firmware from [here](https://dev.px4.io/en/setup/building_px4.html)
I got two problems here:
**Little A**
The px4…
-
**IF YOU DON'T REMOVE THESE FOUR LINES, THEN YOUR REPORT WILL BE CLOSED AUTOMATICALLY**
Questions and user problems should be directed at the forum (http://discuss.ardupilot.org)
_**Please be very s…
-
#### Issue details
Stop mode and Disarming the tracker appear to halt both servo outputs at their current PWM value. This makes sense for standard position servos, but with continuous rotation servo…
-
### Bug report
**Issue details**
_I've done a flight test with master recently, it was the worst long time ago. I doubted that it's due to software/code update. I've done all hardware checks aga…
-
I Think that if during start up parameter is not found is shouldn't be an error, but info. because current implementation assume that its ok not to have parameter, and just treat its non-exist value a…
-
Due to the condition that px4_raspberrypi_* and emlid_navio were splitted, it' s possible to maintain the pure branch of raspi. But developers who work on raspi without navio HATs mostly work separate…
-
**Bug Report**
Hi everyone,
Just downloaded the most recent PX4/Firmware (master-Branch) build it on the Raspberry Pi 3 Model B.
After building an running PX4 the GPS status shows:
pxh> gps status
…