-
Hello,
Very impressed about the project.
I’ve seen it can be used to up to 900mhz but in practice can i measure the impedance at 868mhz?
-
1. #### Coordinating Institute: Amrita Vishwa Vidyapeetham
2. #### Approver’s Name: Dr. Shyam Diwakar
3. #### [Approved Proposal](https://amritauniv-my.sharepoint.com/:b:/g/personal/dhanushkum…
-
Consider updating the foot trajectory during swing phase at 1kHz as well. This may not make sense but could possibly improve performance as the impedance controller is also tracking at 1kHz.
-
Note: make sure it mates well (or, at least will not interfere) with cable glands on the enclosure, [like this](https://www.amazon.ca/White-Plastic-Waterproof-Glands-Connectors/dp/B00843UH4O)
Do no…
-
While the asymmetry between imported and exported functions and resources is directly caused by the asymmetry between guest and host, a symmetrical ABI option would enable direct fusion of components …
-
In physics for numerical simulations we often use complex valued parameters, e.g. dielectric permittivity, impedance, frequency, etc., so it would be natural to support them. At the moment it can be d…
-
**Describe the bug**
Fitting seems to be inadequate for a p(R1,C1) circuit with large values of R (eg 1e+9) e small values of C (eg 1e-12)
**To Reproduce**
Steps to reproduce the behavior:
1. I…
-
In order to calibrate the openbci device (i.e. make sure each electrode is connected, impedance is low), we need to stream data from the board to the 'dashboard' page of the app. The basic setup shou…
-
Errors
-
Hello,
I am not able to change the aspect ratio of the subplot generated by plot_nyquist function. The size can be altered, but the aspect ratio is always around 1:5, regardless of x and y in fig, ax…