-
Hi
I want to interface lsm6ds3 with esp32 and compile it in arduino IDE. I used the sparkfun lsm6ds3 library but the headerfiles were not suitable for esp32.Can i get any guidance?
-
Sampling frequency is a more generic term. Not all sensors as well as not all the platform sensor frameworks support polling, so the "polling frequency" term does not look quite appropriate for generi…
-
Hello kriswiner,
I find all your MPU-9250 board were designed without ground plane under the chip. In datasheet of MPU-9150, the Assembly Precautions section point out
> The exposed center die pad(…
-
Mostly I just wanted to get this issue logged so I don't forget. Currently working on bringup of a new board that is using gyros that operate significantly faster than the rest of redundant MEMS senso…
-
Hi everyone! I'm new to rosflight, I am using the AfroFlight Naze32 Flight Controller (link: https://hobbyking.com/en_us/naze32r6-set-pcb-wire-pins.html) which has the BMP280 barometer onboard. OS ver…
-
Opening this issue to consolidate investigation into a gyro overflow that is the apparent cause of the "yaw spin to the moon". Investigation so far has shown that the ICM206xx gyros are experiencing …
-
It seems like the latest BLE stack from TI has code built in for using the MEMS microphone sensors on board for cc2650stk sensor tag. I have been looking in it but find it beyond my expertise to integ…
-
See this for background: https://github.com/PX4/Firmware/pull/6829#issuecomment-287359454
-
Parameter: (Which) GPS
Useful in following situations:
- can be triggered right before start to have best possible accuracy
- better handling and more targeted than "Telemetry reset"
- GPS (e.g.…
-
There's a number of cases where the sensor provides secondary values which are necessary for calibration (e.g. temperature of the pressure sensor in an altimeter, bias in a magnetometer, etc.). Should…
tobie updated
7 years ago