-
I am new to Zephyr and happy to see the Arduino GIGA R1 is being supported. After installing the basics I have the blink sample running now. I also have an Arduino GIGA Display Shield connected to thi…
-
The 6805 CPUs on hand were all chip pulls and stored in questionable environment/setting, many with bent pins.
Some sort of test circuit is needed to validate that the CPUs are OK. An Arduino shie…
-
I followed all instructions and the gsmshield works fine with mega.
I'm trying to use ehternet shield with gsm shield together:
- pin 11, 12, 13 not conneted to gsm shield but connect to SPI pins
- pi…
-
I'm struggeling using the famos ShiftDisplay version 3.6.1 on the Arduino Multifunction Shield intruduced here:
https://www.electroschematics.com/14128/getting-started-with-the-arduino-multifunction-…
-
I am needing a new shield. Anyone know where I can buy just the shield?
-
Two device tree overlays cannot specify chip-select pins on a single SPI device.
For example, if a board revision introduces a device on an SPI bus, and then a shield also introduces a device on th…
-
Choose which shield we should use (optionally more than one):
- Arduino custom shield
- Shield n.1 https://www.amazon.com/10pcs-XD-212-Multifunction-Expansion-arduino/dp/B0BYXYZF6W
- Shield n.2 https:…
-
![{813CE1E5-A24A-49B8-A504-7E92879E6F13}](https://github.com/user-attachments/assets/202688e5-0e34-419a-a5ca-2c93d3e70c67)
idk how to write in english & use arduino
-
*Sent by Adrian Calugaru (calugaruadrian@gmail.com). Created by [fire](https://fire.fundersclub.com/).*
---
hi guys,
I need a bit of help - i have the below setup:
\- Arduino Mega 2560 (cl…
-
Hello,
I have a problem with homing, hard/soft limits. I have Proxxon MF70/CNC-ready I successfully connect three stepper motors. On each axis I have a button (zero point) what I connected to X+, Y+, …