-
The following steps are similar to those outlined in https://github.com/kintex-chatter/xc7k325t-blinky-nextpnr/blob/main/README.md. I repeat them explicitly below, since there have been different erro…
-
Hello,
So i acquired the xillinx fpga board and ordered MisteX pcb. Maybe it's me but I cannot find any BOM for the parts.
-
**DISCLAIMER:** This probably does not require a litex fix, but I hope it helps others with similar problems and hope to get some hints to resources where I can learn about troubleshooting of such iss…
-
Hey,
First of all, great work on the firmware. However, I've noticed that despite defining `#define BOARD_TYPE BOARD_PICO`, I am unable to control the `pin_rst` as "emulate open drain with pull up …
D4VF0 updated
1 month ago
-
Hi,
I just bought a digilent nexsys video FPGA card and run step -by step to boot Linux according which NaxRiscv document desicribed.
I can boot !!! and login from uart terminal.
But for HDMI o…
-
HI,
MisteX looks like an interesting project. Is there an update what are the current hardware components for MisteX base board? I saw that in the past you were using Allwinner D1, there are mentions…
ole00 updated
1 month ago
-
Dear Sir:
Does any have the vexriscv smp boot up fail problem. the code base which newer than 2021 0401 seems boot up failed if CPU counts > 1.
If setting cpus counts to 1 , the boot up is very …
-
I have board with FT4232 and Cyclone-V
part 5CEBA4F23C7 JTAG ID: 0x02b050dd
and flash EPCS64, which has ID same as
Winbond W25Q64.
spioverjtag bridge doesn't work standalone.
FLASH ID is report…
emard updated
2 years ago
-
I need support for Project Mistral for my chameleon96 and Terasic Sockit Altera Cyclone V boards
A blinky example done with project mistral is done here https://github.com/kprasadvnsi/mistral-CV96-bl…
-
Hello, I just saw the PCB for QMtech that you added a few days ago. Is it working already or is it just an untested concept?
Thanks for sharing, you are doing a great job!