-
The common for the whole EQ3 control is weak BLE signal. Usually weak means lower than -90. Such devices tend to disappear, or loss connection. Such connection needs to be retried multiple times, maki…
-
Das Wixel ist direkt am Akku angeschlossen. 3.8-4.2 Volt
Die Empfangsleistung würde sich bei erhöhter Betriebspannung nicht erhöhen,
da die digitale Schaltung mit einem Onboard LDO Regler auf 3.3Vol…
-
The engine bell on SRBs appears on the side near the top of the part when the SRB loads in. This only happens when entering load range with a flying vehicle. When entering load range with a ground veh…
ghost updated
6 years ago
-
## What problem does this address?
The current component does not:
- select date ranges
- allow users to also choose custom times
## What is your proposed solution?
- build custom calendar for …
-
When configured with certain network configuration, all videos cannot be played, and an error message of "cannot play this video" will appear. However, the same video (and same network setup ) when se…
-
The Luxury Plus has a number of differences including more LEDs, turn signas, headlight, horn, plus the range extender port is removed and the main switch repurposed (rather oddly) as an accessory lig…
-
-
KSP 1.7.0
BDAc 1.3.1
Windows 10, 64 bit
This is a bug I've encountered before with BDAc. Not sure if it's this or Physics Range Extender precisely. When playing for a while, sometimes your cra…
-
Hi,
With every update of sensors EspAltherma goes offline in MQTT.
I see that it sends LWT Offline, then after 6 seconds it goes back Online.
Ping to device is ok all the time.
Is it common/know…
-
So I've noticed that a vessel that is either in orbit or sub-orbital, and passes over something on the ground, it renders the vessel that is on the ground as the vessel in focus on the screen. Sometim…