-
I have observed that the mechanical gantry calibration works best with stealthchop enabled. At the default .12 A current, spread cycle cannot lift the gantry and result in it falling a bit. This might…
-
> I have no idea if its working I have added everything I think.
#####################################################################
# A/B Steppers https://github.com/bigtreetech/Manta-M5P/blob/…
-
I found I was getting inconsistent extrusion with my BMG clone, switching the extruder driver back into spreadcycle cleaned it up so presumably under stealthchop it's missing steps. I've fixed it by a…
-
### Wiki Search Terms
$$ $32 Laser
### Controller Board
MKS DLC32 V2.1
### Machine Description
DIY laser engraver with dual Y motors
### Input Circuits
_No response_
### Configuration file
``…
-
After following the guide, I foolishly looked at the model number on the Y-Axis Stepper and determined it to be the 1.2a model. I also verified that in the printer.cfg they were set to 1.2.
Howeve…
-
I just recently got the SKR V1.3 for the wiring simplicity and 32 bit stuff. Sadly, this has also created a few issues. The SPI jumpers are in the correct places and the +5V is in INT like it is suppo…
-
Hi,
First of all, great work on the library! It has been very helpful!
I am trying to operate a NEMA17 motor and need to know when it is stalled, hence i chose the SilentStepStick TMC2130. I modif…
-
I'm unsure what is causing it, but I can only now successfully home my machine if I disable tmc_autotune for the X and Y motors. This used to work prior to updating today. Here's the relevant parts of…
-
My Nema17 stepper motor operates quietly at speeds below 50 RPM but starts generating increasing noise as the speed exceeds 50 RPM. The noise continues to increase linearly up to 300 RPM. Surprisingly…
-
Hi there,
I am using the TMC5160 with a custom setup for driving actuators, I used them quite for a while with different setups and length and everything always worked out well. For a new project i a…