-
hello, this is not an issue but i didn't know where else to ask. I saw you added support for 5160 and i was wondering if the differences are big and weather the code for 2130 could work for at least b…
-
Hello , did somebody tried to use this library as motion controller mode.
Meaning that sending speed and destination via SPI and chip has full control motor ?
thanks a lot.
-
Hello, Thanks a lot for this lib, I really appreciate the fact that every settings are so clear.
I was using TMCstepper lib before with accelstepper and I'am currently trying to migrate my code to yo…
-
Hey,
I am trying to find the right settings for a Pololu Stepper Motor NEMA 11 Bipolar 200 Steps Rev 28×45mm 4.5V 0.67 A Phase for chopper configuration but even though I calculated the parameters …
-
Hi there i am new to all this programming stuff i have a mks sgen v1 with tmc2209 on x, y, z, e1, axis and lv8729 on e0 i am trying to get sensor less homeing to work and dual z motors z, e1
i am…
-
I've spent hours working with FLSUN to fix the firmware for my custom QQ-S Pro with an MKS Robin Nano V3.1 and a TS35 V2.0.
I have the Homing fixed except, if I offset any axis by a small amount ma…
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
@thinkyhead, based on our discussions at ERRF, I thought I would open a FR for DC servo/encoder support. I know misan has ideas on how this could be approached.
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
I just recently got the SKR V1.3 for the wiring simplicity and 32 bit stuff. Sadly, this has also created a few issues. The SPI jumpers are in the correct places and the +5V is in INT like it is suppo…