-
it would be nice to have a good/automatic test procedure to create a plot as in for steve-m#10
the patch for that was merged with PR: #66
there must be a test/detection program for detecting the f…
-
a newbie question, I get no ham HF reception, I want ham, and 5,10,15,20 WWV for calibration of WSPR bargain tools.
I get the FM and VHF NWS beautifully. I am using a centerfed 20' dipole to 50 …
-
Hello,
What modulation is supported by this firmware for APRS?
-
Eg, it was recieved by a wspr reciever X km away when conneted to X antenna and transmitting on frequency X
-
hello I have a problem with a Light APRS (+WSPR) tracker 1.0 I followed the procedure to the letter I connected the two antennas with sma sockets I compiled and modified the settings that I needed I h…
-
Greetings,
I just installed Wsprry Pi 1.2.0 on a trusty old Pi 3 using a fresh download copy of 32 bit Raspberry Pi OS Legacy (Bullseye). The install of Wsprry Pi went fine.
After configuring t…
AA7US updated
6 months ago
-
Attempting to run some wspr beacons by using the command line and have encountered a new error:
**terminate called after throwing an instance of 'std::filesystem::__cxx11::filesystem_error'
what…
AA7US updated
6 months ago
-
@edegraaff reports that when installed on an OG Pi Zero (no "W"), no time synch service is installed, even if a dongle is added.
Consider checking for a list of `ntpd`-ish services.
-
Hi,
In the "quickstart" at number 7 you mention:
"Initialy the operating HF band is 17 meter (WSPR dial frequency is 18106 kHz)."
I think that should read 18104.6 kHz ?
Ben - PE2BZ
zanco updated
8 months ago
-
Please, consider adding decoders for [RTTY](https://en.wikipedia.org/wiki/Radioteletype) and [PSK31](https://en.wikipedia.org/wiki/PSK31) digital modes. These digital modes are widely used by ham radi…