-
Hey,
I'm trying to use accel_calibration sketch to calibrate my vario.
I followed the directions as closely as I could, mimicking every orientation by how it's portrayed on the calibration video on …
-
Hi,
Thanks for sharing your project. I have a suggestion for you: You could try to implement the Bosch BMP280 barometer sensor. It is much cheaper, than the MS5611 and has almost the same performan…
-
Hi, I'm reconstructing my Quad after a year or so. I noticed that for good reasons they dropped support for the GPS on Cleanflight. So I decided to try INav insted. When configuring my ports, I have I…
-
Hey guys!
I configured everything for a flying wing, saved and rebooted, added some stuff through CLI and saved via the command. But in the pre-arm check (inav 2.0.0) I still get an error in "Setti…
-
I wrote a little python3 script (to be run out of the src/main/targets directory) that counts how many times each #define in the target.h is used overall, my thought being that #defines only used in o…
-
Hello,
I have oscillating flying between two waypoints.
Watch a short video: https://youtu.be/RRVD-rZxHso
The oscillation is seen for 9, 10, 11 seconds.
I've tuned the parameters in inavflight …
-
**Describe the bug**
The ICM20948 in the HERE 2 from ProfiCNC is not detected. WHOAMI value 0x00 is read.
**To Reproduce**
Steps to reproduce the behavior:
1. Connect HERE 2 to Pixhawk 2.1
2. Flash P…
-
I followed [the setup instructions](https://github.com/loboris/MicroPython_ESP32_psRAM_LoBo/wiki/build#building-micropython-for-esp32) on Linux with an m5stack. When I open a REPL I am unable to impor…
-
## Current Behavior
## Steps to Reproduce
1. Update inav to latest
2. use cli to load all current model setting that have working for a year
3. observe all the pre-arm check failures by read…
-
Plane does not pass pre-arm cheks. If the sensor is ICM20608 it is confirmed.
- The board is this: https://www.banggood.com/HAKRC-Omnibus-F4-V3-Flight-Controller-OSD-w-5V-3A-Power-Distribution-Board-…