-
I was having some difficulty getting my filament to feed through the opening into the hotend. I think the filament path should be widened a bit to allow for easy passage of filaments.
-
Hi,
Recently i purchased a MKS Robin E3P board with TFT and WIFI module.
All was working fine, but MKS UI have started to doing random things selecting objects from the UI.
It seems to happens …
-
**URL**: https://www.reddit.com/r/buildapc/comments/cn45w1/amd_stock_heat_sink_and_noctua_fan/
**Browser / Version**: Firefox Mobile 68.0
**Operating System**: Android 7.1.1
**Tested Another Bro…
-
## Brief description of the request/failure
iCubGenova02 hardware check
-
Feature request: I am using 24v to power my Duet 2 Wifi, (upgraded my Ender 3) and my printer is now SUPER quiet, thanks to the TMC2660s. Now the loudest part of the printer is the fans. The quietest …
-
pd0wm updated
4 years ago
-
hello, when I use the gcode M106 S255 without the printer printing, the fan runs at maximum power, while if I use the gcode during a print, it starts at maximum power and then stops after 2-3 seconds …
-
I have a custom built 3D Printer which incorporates 2x color mixing (2-in-1) assemblies fixed mounted to a single X-carrier. The two units are BTT units and I have them both wired to a Azteeg X3 Pro …
-
hi
can I use 24v fan and hot end heater
thank you
-
I'm fighting this issue since a week now and i dont know what else i can do.
Marlin: latest bugfix-1.1.x
Board: MKS Gen 1.4 with TMC2130
E3DV6
Printed thousand of hours withput bigger problems b…
Lyr3x updated
4 years ago