-
Hey!
I got a few TMC5160 for free, but these were early prototypes and have nothing is broken out. Therefore I'm not able to active SPI-mode ([see](https://learn.watterott.com/silentstepstick/pinco…
-
Hello everybody,
my sensorless homing don't work for my ToolGrabber Stepper. On the X Axis sensorless homing works perfect. It looks like a problem that only affects sensorless homing with "manual_…
-
Hi, could you please provide schematics? I'm using tmc2209 with raspberry pi zero w, and this is what I get:
```
pi@pi:~/TMC2209_Raspberry_Pi $ python3 test_script_01_uart_connection.py
---
SCR…
-
I tried to configure 5x tmc5160 with software SPI.
The board is a re-arm with a RAMPS 1.6+ on top.
I prepared and tested a wire loom for 5 tmc5160.
The loom was end to end tested with ohm meter …
-
When using sensorless homing with TMC5160, will the zero position always be set to a full step? Or does it work the same way as with a mechanical endstop, where it just stops on any micro-step, unless…
ghost updated
2 years ago
-
Hello, Im buidling a new coreXY machine with an SKR Pro 1.2 and the EXP-MOT expansion module, dont have a klipper issue need guidance instead. I want to use TMC5160 and the config only shows UART not …
-
Hi
Is the bug with grbl-esp32 and TMC5160 still present in FluidNC? I would like to use stealthchop but with higher Amps than allowed with TMC2130. (I do not have the drivers for now)
Thanks !
boucz updated
3 years ago
-
Kevin:
I've just been updating one of my machines to use some new drivers and the latest klipper code.
What I am finding is that the default of using diag1_stall is not appropriate for these …
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
I recently changed my custom build setup from a RAMPS REARM to a BIGTREETECH GTR 1.0 with TFT…
-
[klippy.log.zip](https://github.com/KevinOConnor/klipper/files/4239042/klippy.log.zip)
I am having the problem, that the extruder does not start.
If it starts it stalls at low speeds or small mo…