-
It would be nice to have a black box log for each arming event. Right now I am only getting one log per power up. If I fly around a bit and then land to make an adjustment, anything after the first di…
-
Recording this while recognizing the F1 targets are no longer officially supported.
From at least BF3.3RC1 gyro initialization fails for the NAZE target. Not sure if this is a generic F1 problem o…
-
iNav 1.3.0.- RC1 creates the same problems when detecting the magnetometer like version iNav1.2.0 did before.
Magnetometer on my NAZE32, a HMC5883, is not found anymore.
-
Matek F722 STD
iNav 2.0.0-rc2
When I flash iNav onto my Matek F722 FC the motor tab doesn't show any of my motors. The only thing I see is a master slider. I used to see all 4 motors but since f…
-
Ok, so my reciever tab on Inav reads all 14 channels as 0. I have the reciever wired up correctly, confirmed in betaflight. It shows all 0 even when no reciver is connected, and only when IBUS is save…
-
Due to problems in the register settings of the MPU6500 SLVx register. Need extensive debugging otherwise the fusion result is wrong.
-
I'm using the "Crius AIO Racer F3 with integrated OSD" which you can find on places like https://www.aliexpress.com/item/CRIU...737854451.html runs extremly well on Betaflight and Cleanflight (except …
-
Board： SP RACING F3_EVO _Brush V2.0 STM32F303CCT6+MPU6500 fireware:betaflight_3.1.7_SPRACINGF3EVO
Issues: Use teensy3.2 to get the the board‘s status by MSP RX . Useing same method, teensy3…
-
In the betaflight standalone app at 10.1, if I start with loop times at 8k/8k gyro_lpf = OFD, and then I select gyro_lpf = experimental in the CLI, the GUI interface changes so that both gyro & PID r…
-
Everyone, this is the changelog generated automatically by using [github_changelog_generator](https://github.com/skywinder/Github-Changelog-Generator), please review.
---
# Change Log
## [v1.8.0](h…