-
1) Spec major components (proc, FTDI, accelerometer)
2) Spec support components (passives/oscillator, voltage regulator?)
3) Schematic
4) PCB v0
5) Order parts
-
We need someone help us design the pcb?
-
Hi,
in issue #15 it is also mentioned, but for a different reason.
I recently discovered this great project, absolutely terrific work!
I have a lot of experience with Open Source projects, so i…
-
This will enable the "stampie" design for tying down stamp modules.
This is something that only electronics as code could really do effectively, you basically try to squeeze in a stamp module using 0…
-
I'm creating this issue to keep track of the progress on the various circuit board designs needed for SimplePnP.
Remaining work:
- Main controller board (very similar to the head mounted control…
-
An open task from last year that was not accomplished. Needs to replace the solderless breadboard on each platform with a (more permanent) PCB. Design needs to be reviewed by the admin team before any…
-
Hi, I found out this repo and really interested to make it but I am not friends with hardwares yet. I've been looking into building some of your hardware.
I have a question regarding our current PC…
-
prototype a fully working schematic and create a pcb for it.
Should be mounted on the left inner side of the slide (where the mode selector is mounted). Goal is to have only one long pcb left, that t…
-
1) Подписать светодиоды что за что отвечает (исправлено)
2) Перепутаны NO и NC в реле на футпринте (исправлено)
3) Убрать 110 вольт постоянки (исправлено)
4) шелкография R7, R27, R215, (исправлено…
-
The PCB design doesn't have any values for the resistors. Once we've tested some boards we should note the values in Kicad.