-
http://www.reprap.org/wiki/Firmware_Capabilities_Protocol
> M531 filename - Set the filename being printed.
> M532 X L - Update current print state progress (X=0..100) and layer L.
>
> This al…
-
Cura now has its own "UltiGCode" flavor as well as a "Reprap (Volumetric)" (due to the begging a pleading of yours truly). The difference between these two modes is that UltiGCode has a few special co…
-
### Version
Version 2.3.55
### Operating system type + version
Windows 10 version 10.0.18363 build 18363
### 3D printer brand / version + firmware version (if known)
voron 2.4 with duet wifi/…
-
### Version
2.2.0+
### Operating system type + version
Mac OSX 10.14.6
### 3D printer brand / version + firmware version (if known)
Custom, Reprap based, Duet3D controller.
### Behavior
I…
zapta updated
4 years ago
-
### Description
While I was able to run the LCD display on an e3 mini board, after swapping the board I'm not able to use the Maylan lcd.
I've connected the tx/rx pin od the screen to the TFT…
-
```
What steps will reproduce the problem?
Uploading bootloader for 644/1284 with Arduino IDE using the provided
boards.txt.
What is the expected output? What do you see instead?
I have an Sanguino …
-
using ";" for comments renders them white instead of green. I had to switch back to the original nc-gcode version to get them green again.
Is there a setting I am missing in the preview version?
-
### Bambu Studio Version
1.8.0.62
### Where is the application from?
Bambu Lab github releases
### OS version
All
### Additional system information
Doesn't matter.
### Printer
X1C
### How to…
arekm updated
7 months ago
-
```
What steps will reproduce the problem?
Uploading bootloader for 644/1284 with Arduino IDE using the provided
boards.txt.
What is the expected output? What do you see instead?
I have an Sanguino …
-
```
What steps will reproduce the problem?
Uploading bootloader for 644/1284 with Arduino IDE using the provided
boards.txt.
What is the expected output? What do you see instead?
I have an Sanguino …