-
Hi,
why you change the level Points at the Leveling Menu.
From 1.02-1.04 to now 2.0 you change the 4 manual leveling points,
or only the icons, can you correct this or is it a needed change!?
…
-
Hi,
with double Z only Z,
double optical/mechanical endstops,
endstops on Z **triggered** after homing,
power off,
restart,
now you can't move any axis over manual menu,
homing on all a…
-
He montado el doble extrusor en mi impresora Tevo Nereus. Tengo conectados los termistores y funcionan bien midiendo la temperatura de los dos extrusores.
Pero el problema lo tengo al conectar los…
-
Upon entering a down ramp sensor temp stayed same temp got stuck at 805 degrees c it went into a hold or something and did not down ramp heater turned off though I had to restart pi for it to read tem…
-
I have been toying with the idea for a few weeks now about unifying some of the communications with 3D printers. And thereby future proofing the 3D printer market.
One of these ideas, is looking a…
-
I'm not sure if this is a bug or operator error.
I have tried many combinations of setting up the thermocouple for the E3D V6 hotend on the Bigtreeteck MKR Pro board. I am using the thermocouple ampl…
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…