-
I would like to use the [BigEasyDriver](https://www.sparkfun.com/products/12859) to drive a stepper motor from the Arduino.
I've chosen Cylon over Johnny-Five because, although newer, I believe Cylon…
-
Hello,
I have an ortur 4 with skr 1.3 motherboard.
On Y I have install MKS-SERVO42C with success on a nema 17 39mm.
Then I have install the MKS-SERVO42C on a nema 17 60mm and the issue start …
-
wsh32 updated
2 years ago
-
I cant get sensorless homing to work.
What ever configuration i do, it doesnt work. different ^, ~, ! setups, does only change if it does nothing (not moving) or not stopping.
If i change the sense …
-
Hi there,
I have installed a SKR1.3 with TMC2209 stepper drivers. The steppers make a lot of noise when printing. I tried to set the current without success. If Stealtchop is deactivated, no differ…
-
### Is your feature request related to a problem? Please describe.
I want to connect MKS SERVO42C NEMA17 Closed Loop Stepper Motor Driver to an SKR 3 board. Is the "MKS SERVO42C NEMA17 Closed Loop St…
-
Hi,
I have used my Ultimaker a few times now and works pretty nice. Now up a sudden it is giving ma a hard time. I start a print that would take about 10 to 12 hours of printing, but after a few hours…
-
I have ramps 1.4 with mega 2560 and i connect my steppers with A4988 Driver but its not working and my HC-06 not working too but my servo is working well here’s my code :
#include
#include
#inclu…
-
hello there I'm just wondering if anybody can shed some light on an issue I am having with the output to the stepper driver.
I have loaded up the software V 1.1.02 onto the launch board and I have…
-
Hello I have a problem again. The board arrived and I got it working. I did calibrate the Z endstop and the probe everything was working fine. I did change the fan connection to PB2-24v 2x controller …