-
https://github.com/Egyras/HeishaMon/blob/c08377209c3e0c61fd99201f560fd62b46797edf/Integrations/Home%20Assistant/heishamon.yaml#L576-L613
Please fix that, COP calculation should be after power calcu…
-
In the schematic there is no level converter for the TX part.
This means that the heatpump only gets 3.3V as TX level.
Most proberly due to voltage drops, the heatpump get only 2.7V as TX level
I…
-
- Connecting a S0 kWh meter to GND and the port marked '1' on the PCB makes it show up in software as Port '2'
- MQTT topics for S0 connected on Port 2 is described in Readme as:
panasonic_heat_pu…
-
Good evening.
I like your project and PCB and would like to use it in my house. I tried to purchase `HeishaMon v3 communication PCB` from the Tindie store but it will not ship to Australia. Is there …
-
Possibility to start/stop the solarpump who is connected to expansion board.
Start/stop is automatic in Panasonic when solar temp is higher than SWW sensor temp.
-
Hi!
Having an air-to-water Panasonic Aquarea heatpump installed in november this year I might be interested in building on and extending what you have started here. Do you have any documentation on t…
-
Hello,
I've realized (from your aquarea2mqtt) a new golang version that uses cloud for read/write on mqtt and I can switch on / off and other functions from hassio. My solution (as aquarea2mqtt) is a…
-
Hello,
I've upgrade with your firmware but I have only ssh...
How to connect to luci?
Thank you.
-
Witam,
Chciałbym zainteresować Pana projektem https://github.com/Egyras/HeishaMon
Teoretycznie cel ten sam , metoda inna ( bez użycia SmartCloud).
Pozdrawiam
-
HeishaMon version 8.1.2019
Build with VSCode
Arduino.json
`
{
"board": "esp8266:esp8266:d1_mini",
"configuration": "xtal=80,vt=flash,exception=legacy,ssl=all,eesz=4M2M,ip=lm2f,dbg=Disa…