-
What parts should be used?
- ESP?
- Sensor?
- Battery?
- Battery Management (Charger, Protection)?
- ..
-
Hi,
I would like to know if it is better to use a DC Adapter for Arduino One or some solution for EVShield?
http://playground.arduino.cc/Learning/WhatAdapter
-
Hello, I have 3 inkplate devices here with standard off the shelf 3.7v li-ion batteries plugged in and I cannot get any of them to charge. Is there any special software definitions that must be set fo…
-
when I am trying to connect the module with Li-ion battery with 4.2v it is not connecting to the internet. but when I connect with the type-C port. I am getting the internet and pushing the data.
…
-
investigate if it might be used SEC_FEATURE_PREVENT_SWELLING
```
dumpsys battery
Current Battery Service state:
AC powered: false
USB powered: true
Wireless powered: false
Max chargin…
-
- We need to implement a new battery management system in YouBot to use hot-swap of battery.
-
While attempting to reboot my Raspberry Pi 4 Model B, the PiJuice LEDs stayed red with a blue flash. The Pi is plugged in continuously, so it should not have been low battery. After removing the batte…
-
On my iPhone I see that values below 0.2A are not shown. The display then stays at 0.00A. Please show values as low as 0.01A. I charge 32 (4S8P) Li-ion cells by a 50Watt Solar Panel for charging my iP…
-
Hello and welcome.
I have a BMS as in the topic and it works with seplos ver2.0, but not everything is decoded correctly. Send data:
~25014642E00201FD30
answer:
~25014F4280800001 0E 0DD2 0DD2 0DD3…
-
**What has to be done**
We need to finalize the UPS/Battery capacity required for Current ventilator. And need to resource it for the medical graded one which is easily available for supply chain.
…