-
I cloned RC6 and then used a diff tool to carefully copy over only the relevant configs from my RC3 Configuration.h to the RC6 Configuration.h and uploaded to the arduino board on the printer (using A…
-
Update to RC6, everything uploaded fine, it just won't connect. Tried Repetier Host and Octoprint.
Appears to be a Marlin-specific issue, if I install Repetier Firmware, I am able to connect without…
ghost updated
2 years ago
-
Hello. After G29 command not working raise between probing points. I don't understand why or what wrong I do?
Marlin 1.1.0-RC7
This is my configuration.h:
``` cpp
#include
/**
* Marlin 3D Pr…
-
Issue moved from reprap forum (http://forums.reprap.org/read.php?415,645165)
Marlin 1.1.0 rc4 - Smartrapcore alu (corexy) printer issues with auto-levelling grid. Working previously on Rc3. With a f…
-
Any bump in my nozzle based z-min probe that closes the switch causes the layers of my prints to shift. Manually triggering the switch reliably reproduces the issue. Confirmed that this is an issue on…
-
OK all Anyone have any ideas on what is going on. I have been working on getting a BLtouch working for about a week now and I haven't been able to get it working yet. i finally today got it to move up…
-
So I recently built a Pegasus 12 by Makerfarm and decided to install Auto Bed Leveling using a micro switch and servo. I downloaded the current version of Marlin and have been editing ever since. Ho…
-
So I did not see any information on this anywhere in my numerous google searches. I have a melzi 2.0 board that I had recently replaced. I have everything reconfigured from my previous settings but I …
-
I am using a custom Delta printer.
I was working OK with RC7. Today tried RCBugFix and can't get auto bed leveling working right.
Goas down to bed at negative X until tohchs the bed.Then moves right…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
I'm new to Marlin, and relatively new to 3d printing. This is my first printer, Ender-3 with 4.2.2 M…