-
Hello,
I bought these two sensors:
DHT22/AM2302 Digital Temperature Humidity Sensor Board
US-015 Long Range 700cm Digital Ultrasonic Arduino Distance Sensor Module
Has anyone interfaced these with t…
MrAda updated
8 years ago
-
The BMP180 sensor is read via the I2C bus. Use the Adafruit library and adapt it for this project. Then add the .c and .h file to the repository.
-
# Task # 01
## Execute all tests on `native` and check their output:
- [x] bitarithm_timings
- [x] bloom_bytes
- [x] coap
- [x] conn_ip
- [x] cpp11_condition_variable
- [x] cpp11_mutex
- [x] cpp11_thr…
-
# Task # 03
### Perform a subset of tests (!= subset from [Task #02](https://github.com/RIOT-OS/Release-Specs/issues/23)) on [`samr21-xpro`](https://github.com/RIOT-OS/RIOT/wiki/Board%3A-SAMR21-xpro) …
-
My micro quad is drifting to the right in ANGLE and HORIZON mode. It gets stronger over time until I really have to fight the quad hard not to drift. As you see in this video the drift grows over time…
-
The pocketCHIP exposes the i2c-2 pins but not i2c-1 so changing the default to i2c-2 would it possible to use J5 i2c on the pocketCHIP.
Also /dev/i2c-1 is not available on Headless 4.4.
```
chip@chi…
bbx10 updated
8 years ago
-
I couldn't make the BMP180 example run. I'm using the BMP version with only 4 pin and an RPi3, though I'm guessing those two should not make a difference.
I was using the example code found in cylon w…
-
Connect the barometer to FCB and read input. Recalculate input to give a rough estimate of altitude.
-
I need to regulate the pH of medium with CO2. Can you please add the pH Atlas scientifique sensor with relay function, and calibration?
Thank you very much
-
Connect and collect data