-
At the moment, the sanity check plug-in takes a `reference_receiver_index` parameter, which is basically the antenna/dish number, e.g. `reference_receiver_index=0` refers to `m001`. Only the scan trac…
-
Hi, I'm looking to build a similar device with a Lora E5 with sensor and since I'm not an expert on the RF field and looking for similar designs to learn from I came across your AERQ project, I would …
-
I configure gw with 91 MHZ Band, in the frequency 913.88
I read the antenna tuto but i dont understand.
I need to make a cut at 21 mm? to tune? (I see the yellow curve)
Thanks in advance
-
Thank you very much for such an excellent application; it is truly beautiful and accurate so far!
I would like to report that the commands for controlling an antenna rotor are not the same as Gpred…
-
Is there a way to connect an external antenna to extend the range of Wifi and/or ESPNOW?
Thanks!
-
Work on the antenna tracker has been started, but never tested. I want it to interpolate the MAV's GPS stream, so that it updates at a faster rate giving smooth servo output. It might pay to make use …
-
@TobleMiner , congratulations for nice work.
Where can find more information about the antennas you have?
Thanks
-
We need a cutout/antenna of some sort for the payload package, as we'll have no luck transmitting and receiving from inside a metal box.
-
### Platform
ESP32
### Assembly
I did the assembly by myself
### nRF24L01+ Module
_No response_
### Antenna
external antenna
### Power Stabilization
Elko (~100uF)
### Con…
-