-
Not a major issue as you've said you've got several others on the way for testing, but the link to the motor you used is now out of stock: [AliExpress](https://www.aliexpress.com/item/1005001384349991…
-
Introduction
Building a lower bot to competition specs that has all the main components necessary in order to take in user commands and respond accordingly. It should be a platform for our localiza…
-
Thanks for the good info. Have you managed to find a replacement part for the fan motor? I have an older model, I think circa 2016 that has a Panasonic motor with similar specs. So I would assume I co…
-
I noticed some time ago that bluesky seems to perform relative motion with respect to the readback value. Almost all of the EPICS motor implementations i have seen for "jogging" or incremental step…
-
hello friends,
and a big thank for the challenge to build and further study such interesting machines.
my computer runs linux with freecad, so my build will rely entirely on the STEP exports and p…
-
I'm running a ArduinoNano where GRBL crashes after 2..20 minutes. It has nothing to do with the data I sent, so no matter what shapes I move and no matter what GUI I use, the problem is always reprodu…
-
Could you kindly publish the configuration.h/configuration_adv.h for Ender 5 which was used to build the binaries for SKR-mini-E3-V3.0?
All you released are the ones for Ender 3
Thanks in advance
-
Hi,
I realizaed that randomly while printing, the steppers start to make noise and become very very hot, more than 80C (untouchable).
After lots of reading and tests, i think the problem comes w…
-
Hello,
I am trying to sync read and write data to multiple Dynamixels.
Setup:
OpenCR board
2x MX430-W350-T
2x XM540-W270-T
2x XM540-W270-R
Writing is no problem.
But reading produces pr…
-
This firmware works best with capacitor values ~20x smaller than are found on almost all ESCs. However, this could be tuned for by adjusting the new TIMING_OFFSET feature. It could be calculated as fo…