-
Hello I was wondering, is it feasible to add the "H" extension for hypervisors to the 64bit core? Or would that require too much re-engineering of your existing design ?
I am asking because hardwa…
-
Hardware :
- Board : https://www.efinixinc.com/products-devkits-titaniumti375c529.html
- HDMI : https://www.digikey.com/en/products/detail/efinix-inc/EFX-HDMI/17084519?s=N4IgTCBcDaIKYDMCWA7JAPABACw…
-
Hello jbilander,
I am new to github, so this may not be the right or best place to get in contact with you. If there is a better way, please give me a hint.
I registered here, because I am cur…
-
Currently microload firmware only works on the Opsis. It loads stuff via the hardware I2C controller with the FPGA emulation something like an EEPROM.
This doesn't work on the Atlys because the FPG…
-
## download
https://www.xilinx.com/support/download/index.html/content/xilinx/en/downloadNav/vivado-design-tools/archive.html
## deps
```bash
sudo apt install libtinfo5 libncurses5
```
## in…
-
# [인공지능 가속기 설계] Artificial Intelligence Accelerator Design (Using Zynq-7000 FPGA, CDMA, AXI)
[https://radic2682.github.io/project/hardware%20project/2023/12/08/ai.html](https://radic2682.github.io/…
-
I'm trying to do some dev with this FPGA but Gowin seems not to run on Mac, was wondering if I could use this Docker for it?
https://wiki.sipeed.com/hardware/en/tang/Tang-Nano-9K/Nano-9K.html
-
# [LiteX] QEmu simulation of a LiteX generated SoC
More technical details at [Issue #86: Get lm32 firmware running under qemu to enable testing without hardware on HDMI2USB-misoc-firmware repo](htt…
-
Matlab supports [hardware design](https://www.mathworks.com/discovery/hardware-design.html). Hardware blocks are connected together at a high level using Simulink to create a system, that can then gen…
-
### Board
ESP32-S2-WROVER-I
### Device Description
WROVER module on custom board (see below).
### Hardware Configuration
Serial port (UART 0):
GPIO 0 - DTR
GPIO 43, 44 - RX/TX
…