-
Hi,
I'm using an M25 inside my print to pause my printer halfway. This works except that the bed is not put into active mode again after I resume the print. It stays on standby, which appears to be…
-
Hi, awesome to see this!
Can you please provide more info such as a wiring diagram, ESPhome code, supported heaters etc.
Thanks!
-
### Feedback
[Glamox](https://glamoxheating.no) is a brand used by Adax, for example their [3001 Wi-Fi & Bluetooth thermostat](https://glamoxheating.no/produkter/3001-tpa-tlo-wifi-bluetooth-termostat…
-
Thank you for the work on the library.
I plan to integrate my aeroflow heaters with iobroker and that looking for libraries which have been working on the integration.
Found yours and seen it has …
-
Would like to figure out how to add bounded temperature setting sliders (or other) to the heaters. Presumably since these are water_heaters there is a common way to do this. I'd leave the minimum se…
-
When I disable the heaters using a processor,it still generates heat.
Although rejoining does solve the issue though
(can't show the video,its too large but you can recreate this with a processor an…
-
I investigated a little bit further the problem I have with version 1.5 (last working version: 1.4.4) and my Thermor heaters "Equateur" (it is even crashing the heater at some point (no possibility to…
-
After connecting the Lcd, it boots up fine. I can control the bed and extruder temperature with no issues. However, when I start a print and then manually hit Stop, the print stops, but the extruder…
-
# Top-View-of-a-Tree
## 入选理由
暂无
## 题目地址
[https://binarysearch.com/problems/Top-View-of-a-Tree](https://binarysearch.com/problems/Top-View-of-a-Tree)
## 前置知识
暂无
## 题目描述
…
-
With Marlin-bugfix-2.0.x-SKR-V1.4 release of 31/01/2021, when I set EXTRUDERS 0, the compilation cannot end.
Compiling .pio\build\LPC1768\src\src\lcd\extui\anycubic_chiron_lcd.cpp.o
In file includ…