-
### Required prerequisites
- [X] I have read the documentation .
- [X] I have searched the [Issue Tracker](https://github.com/PKU-Alignment/omnisafe/issues) and [Discussions](https://github.com/PKU-A…
-
-
Hey Nick, thanks for your blog posts and code. Been learning a lot!
I haven't managed to get any of your code running on my macOS (some issues with `g++-13` when trying to run make) but have had s…
-
I am using Juniper to solve an orbital insertion problem for a LEO satellite. Treating it as a non-linear and non-convex optimisation problem. However introducing the first-order hold dynamics constra…
-
How hard would it be to pickle [AugmentedLagrangianNonSmooth](https://drake.mit.edu/doxygen_cxx/classdrake_1_1solvers_1_1_augmented_lagrangian_nonsmooth.html)?
Pickling `AugmentedLagrangianNonSmoot…
-
Configuring what is output from the UM is [confusing for most users](https://forum.access-hive.org.au/t/controlling-outputs-in-access-cm2/1809).
Rachel Law suggests there could be a pre-configured…
-
### Question Validation
- [X] I have searched both the documentation and discord for an answer.
### Question
Hello, thanks for your time in answering this!
I am running into some issues wit…
-
## Keyword: super resolution
There is no result
## Keyword: gan
### Towards Discovery and Attribution of Open-world GAN Generated Images
- **Authors:** Sharath Girish, Saksham Suri, Saketh Rambhatla…
-
maximum g measured in breakers exceed 8g. sfy is usually configured up to maximum 4g.
- [ ] Configure IMU correctly
- [ ] Adjust max acceleration in serialization
@article{sinclair2014FlowRider…
-
I'm trying to extract nodal outputs at each of the blade stations in Elastodyn, but when I run OpenFAST I get the following warning:
```
Running ElastoDyn.
Nodal outputs section of ElastoDyn inpu…