-
### Description
Would like Tone() to be implemented on the LPC HAL
I have looked and am not sure there is a timer free for this, or if there is just not a timer implemented that can be used. I h…
-
Hi there new to marlin and working with a MKS Gen 1.4 and been doing good on it, Got it all working and I noticed after testing the hotend and heatbed for stability for an hour, I looked at the LCD an…
-
### Bug Report
I'm using Marlin v1.1.6 with RAMPS 1.4 with full graphic Smart Controller. I've changed from a thermistor to a thermocouple K-type using a MAX6675. I've changed the sensor type to -2 i…
-
### Bug Report
**- Description:**
After issuing the `G29` command to use the Bilinear Leveling feature, the printer does not react to either the `M851` command nor to a change in the `Z_PROBE_OFFSET…
-
Hello.
Forgive me as I am newer to marlin and I feel this issue has a simple solution.
I have upgraded my tronxy x5s to use arduino Ramps 1.4 combo with Tmc 2130 stepper drivers with the setup f…
-
Im trying to install an Aibecy Anet 12864 LCD Smart Display Screen Controller on my Anet a8 and im getting errors after i enable "#define DOGLCD" and im getting this error "'DOGLCD_CS' was not declare…
-
### Bug Description
I got a problem with Anet a8 plus, My capacitieve sensor goes outside my bed to measure, when I try to auto level.
I use marlin 2.0 and search everywhere for the solution. …
-
on uncomment #define CNC_COORDINATE_SYSTEMS in config h adv
```
In file included from sketch\src\Marlin.cpp:49:0:
sketch\src\gcode/gcode.h:400:10: error: 'bool GcodeSuite::select_coordinate_s…
-
Stumped… I must be doing something wrong!
I am trying to upgrade my stock ANET A6 board to Marlin so I can add a BLTouch. It seems that the program is slightly too large to fit and fails to load w…
-
I have tried all three auto leveling methods but none of them works correctly.
```cpp
#define AUTO_BED_LEVELING_3POINT
#define AUTO_BED_LEVELING_LINEAR
#define AUTO_BED_LEVELING_BILINEAR
```
No …