-
### Version
2.1.3
### Hardware / Firmware
TinyG
### What happened
When running the Z probe module, my CNC appears to correctly interpret the `G38.2 Z-20 F100` command and lowers Z until…
-
Hello!
Is there a particular platform (Rasp. Pi, Arduino, ESP32, etc.) and a particular LoRa device that is recommended for compatibility with your project?
There seem to be a lot of choices in …
K4KDR updated
3 years ago
-
Homing X and Y can time out on larger machines. Mine is 630x530. As maximum travel distance and speed is known, we could calculate a realistic timeout.
-
If I click stop in the middle of a place job (or reset TinyG by hitting either limit switch or closing reset switch), the software behaves strange.
At first it appears to be busy for up to a minute -…
-
Point 2 from https://github.com/synthetos/TinyG/issues/69 is still an issue.
"When testing my limit switches (All six) which are configured NC, I receive this msg from tinyg.
{"er":{"fb":414.03,"st…
-
Hello,
I am having an issue the PCB Auto Level feature.
Physically, it trips out as soon as the z axis goes to lift up after the first probe. I am on firmware version 440.20.
I changed the limi…
-
I have a typical setup of tinyg and Rasberry PI running SPJS, my computer is few meters away from my CNC machine, sometimes I need to adjust XTZ and zero the machine when I'm near it without going bec…
-
Any luck getting OctoPrint controlling a tinyg? I'm seeing the output in 'terminal' when I issue commands by echoing directly over usb, but octoprint sticks at 'connecting.'
-
#### Description
I have upgraded CNCjs from 1.9.13 to 1.10.1 and upgraded my TinyG v8 with recommended firmware build 449.01.
After setting back all parameters on the TinyG, I still have a problem…
-
Generally, Spindles take some accelerating time to reach the rpm desired, after sending M03 or M04 the controller starts immediately the next move even if the spindle does not reach the speed, this ma…