-
hello mark,
i am having difficulties in connecting a pixhawk through a nucleo moab board. how do i make connection between the two? i am using a brushless dc motor, is brushless ESCs necessary? or ca…
-
sorry for opene an issue.
i did buy a ub482 board. i am on the start with it..
do you have experiences with the 482?
is it possible to compare it to other dual antenna boards like trimble mb2 …
-
Currently only 10 Hz update rate is supported. When using all GNSS-constellations, this rate is not supported by zed-f9p-devices, so lowering it could be beneficial.
-
### Bug report
**Issue details**
EKF3 does not initialise when using GPS_AUTO_CONFIG=1 with ZED F9P
With GPS_AUTO_CONFIG enabled the GPS is detected but the console shows repeated:
"APM: EKF3 …
-
Hi!
I have been following all the installation steps on a Raspberry pi 3B+. ./build_rtkbase.sh seems to build everything fine, but there is no RTKBASE in the folder that I can run (./RTKBASE). Any …
-
RTKExplorer RTKnavi binary (b31a ) crashes (on aWindows7 x64 host) if configured to work with the following configuration:
- UBX ZED-F9P
- PPP static (or dynamic)
- Correction source SSR CLK93
- C…
-
### Subject of the issue
Hi,
I have connected uBlox MAX-7Q to Arduino Nano. Using this library and example "Example11_UseUart" from this library I was able to connect uBlox to Arduino, but all I rec…
-
Hello doppelgrau.
It is a wonderful work!
I want to use this board for NTRIP Client to F9P, and AutoSteer to AgOpenGPS .
Do you think it is possible in ONE esp32?
-
Hi!
When I run:
```
rpminspect -F json java-1.8.0-ibm-1.8.0.6.0-2.el8 java-1.8.0-ibm-1.8.0.5.40-3.el8_0
```
I got shell-syntax results like this:
```
"shell-syntax": [
{
"result":…
-
The geo question types that use maps show the accuracy radius of the current geolocation at the top of the screen. The geopoint question types show two digits after the decimal point but the geotrace …