-
My SKR Mini E3 board is working fine by it self.
But when ever I am trying to connect with my Mac machine the stepper motor starts buzzing sound and Board stops working completely. Only a hard reset …
-
I am having trouble with the x- axis stepper motor jumping ,not belt,not to hot printer raised 20MM off table,it will be printing nice then for no apparent reason moves(jumps) about 1MM off . the ste…
-
To prevent dangerously high LC spikes, Pololu recommends placing a 100uF capacitor across the rails of each driver, as [outlined here](http://www.pololu.com/docs/0J16/5).
Currently, a single 100uF ca…
-
I use the library with an Arduino Uno. `Simple.ino` works exactly as expected. I use this pin setup:
```
#define EN_PIN 7 // Nano v3: 16 Mega: 38 //enable (CFG6)
#define DIR_PIN 6 // 19 …
-
### Is your feature request related to a problem? Please describe.
Actually I have dual Z drivers and invidual Max Z homing sensors. On Lerdge original firmware it's possible using the Ex-Axis functi…
-
@jonmagic opening a new thread here on porting the code. reading over things today, I noticed the author notes the code may need to be ported for the Yun. (i guess it uses different pins or logic th…
-
Hi!
I downloaded the GcodeCNCDemo4AxisRAMPS.ino from your github site and modified to add 5th stepper motor.
When i try to run, i here humming noise from stepper motors.
I tried all combination…
-
This is a very cool project!
Could this technically be done with ESP-01 that has only a few outputs?
Also, it seems that the Android app is only sending GET requests which could be doable with a w…
-
Hello, I will be using a teensy 4.1 and 2 TMC2209 V1.3s wired directly without a shield.
For the 2209 V1.3, is spreadcycle the default mode? If not, how do I switch it?
If I just have to us…
-
Can someone running their ERCF off the Printers Mainboard instead of an Addon Board share their ENTIRE Printers config package?
The broken Installer ( providing 7 Options but only accepting 6 ) doe…