-
ISSUE TEMPLATE ver. 0.0.1
1. Which TurtleBot3 you have?
- [ ] burger
Burger
- [ ] waffle
- [ ] waffle pi
2. Which SBC(Single Board Computer) is working on TurtleBot3?
- [ ] Raspberry Pi…
-
I've been using the TurtleBot3 Waffle with Intel Joule processor for about a month now, and everything has been working very smoothly up until yesterday. Yesterday I followed the same process I usuall…
-
### Conditions
- Newly purchased (arrived **03/02/2018**) OpenCR Board from Turtlebot 3 Burger
- Powered from fully charged LiPo Battery that came with the kit
- Also tried powering from SMPS…
-
Hello all,
I recently bought turtleobt3, it came with dynamixel motors Xm430-w210-t, intel joule and openCR board. I followed the tutorial and done all the steps.
when i launched turtlebot3 bri…
-
Hello all,
I recently bought turtleobt3, it came with dynamixel motors Xm430-w210-t, intel joule and openCR board. I followed the tutorial and done all the steps.
when i launched turtlebot3 bri…
-
arduino 1.8.1
error messages -----------------------------------------------
Copyright 2010-2016 Tormod Volden and Stefan Schmidt
This program is Free Software and has ABSOLUTELY NO WARRANTY
Ple…
-
Hello,
I have bought 5 tbots presently.
I have already followed the instructions [here](https://discourse.ros.org/t/turtlebot3-software-and-firmware-update-and-waffle-pi/3729). I am running the 1.0…
-
Hey! I've replaced a Dynamixel for my turtlebot..
Strangely, it is not recognized by the robot, even if checked the setup:
- firmware 41
- ID 1
- Baud 1Mb
Anyway, when I try to run the "…
-
Hi ROBOTIS-Leon,
I have problem in finding library "dxl_x64_c" in Matlab using both protocol 1.0 and 2.0.
The problem is this:
I have downloaded package "DynamixelSDK-3.3.3" to use it in Matlab…
-
Hi,
I am trying to setup the OpenCR Board to control four DYNAMIXEL XM430-W210-R by daisychaining them. However unfortunately, none of these motors seem to work.
I already tried multiple examples f…