-
iCub **iCubNottingham01**
### Description of the failure
Every time that I run the yarprobotinterface I get the following errors:
[ERROR]Right_Arm_Calibrator : checkGoneToZeroThreshold: joint 0…
-
At startup of ETH robots (just tried on `iCubGenova05`) the following error is printed by the `yarprobotinterface` :
```
39 0,313448 ERROR HasSpeedEncoder parameter not found
77 …
-
After #230 was fixed, we faced two kinds of errors and many warnings. Our errors relate to communication with the Ethernet boards and the configuration file apparently in the wrong version.
Bellow a…
-
Hi, I am with @robertocalandra and Alex Paraschos, we are trying to update the iCub firmware in iCubDarmstadt01. After updating with ethLoader, we have version 2 build 15 on all boards. Launching the …
-
После обновления статус программы
"защита на паузе" хотя интернет есть.
Проблема появилась синхронно после
обновления на Samsung S7 EDGE и Samsung J5
1327270
{
"advancedPreferences" : {
},
"an…
-
Hi all,
We updated the firmware in our iCub and we have and eth resources issue. The version of PC104 is 5.0-15.03.31. Please see log file.
||| configuring
||| no policy found
||| default config fil…
-
Hello,
We have an issue with iCub torso, which doesn't start during the calibration process. It seems that the motors are not powered. Also, in the yarpmotorgui the three joints of the torso are in r…
-
Hi,
we had some slack in the wrist yaw joint and fastened the tendons using the tensioners. Now after starting the robot the wrist yaw joint is not centered any more (it is at the positive extreme). …
-
```
Hello.
I'm upgraded my old PCT jar (build 138) to the latest version (build 170), in
order to get support to Progress version 11.1.
But now, even warnings in the database creation is failling m…
-
```
What steps will reproduce the problem?
1. Simply init x360ce.exe
What is the expected output? What do you see instead?
Possibility of mapping buttons in main screen, grey pad instead. However, i…