-
via conversation with @ajfisher on gitter:
There was a pull-request for SPI opened a while back: firmata/arduino#135. However, it's going to be more complex than just wrapping the Arduino SPI api (si…
-
### Bug Description
This is `bugfix-2.0.x` commit d84aff701e10a49d5ccc69ce323fdb0fdb84b6db
Long travels exhibit stuttering movement when ABL is configured and enabled.
If I switch ABL off by …
-
This is only bug and feature tracker, please use it
to report bugs or request features.
----
### Issue details
Hi everyone,
I want to send my quadcopter to the latitude, longitude and alt…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
### Did you test the latest `bugfix-2.1.x` code?
No, but I will test it now!
### Bug Description
WITH SYNTAX G2/G3 X Y Z I J F THE AXIS DO MOVE BUT VERY SLOWLY
This potential bug was first repor…
-
Parent Issue: #76
The list below are files that have been released in the past by BES. These files are largely similar to those previous releases but include changes that have not been explicitly …
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
### The problem
Using this `/config/rtl_433/rtl_433.conf.template` file:
```conf
# config for rtl_433
# A valid config line is a keyword followed by an argument to the end of line.
# Whitespa…
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…
-
### What happened?
After upgrading my VM (Ubuntu 22.04 / amd64) to the latest available kernel (`5.15.0-1023-aws` and `5.15.0-1022-gcp`), service probes stopped working. I checked older versions of…