-
Given that this unit is able to detect missed steps could this functionality be adapted to allow for sensorless homing ?
-
### Operating System
Linux
### Board
stm32L4x2
### Firmware
Compilation to a stm32l4x2.
### What happened ?
I tried to compile stm32fs_dev driver for stm32l4x2, I configured CFG_TUSB_MCU to OPT…
-
Currently the `TIM` peripheral only has a v1 version. While newer timers still seem to have the same registers and fields, some of them have extra functionality added.
I ran into this when I wanted…
-
Not sure if I should post it here or on the PlatformIO page, do let me know if this is not the place!
**Describe the bug**
I wanted to setup a project for STM32G431CB with the Arduino framework (t…
-
Hi,
in the release note of the CubeG4 v1.2.0, it is mentioned:
https://github.com/STMicroelectronics/STM32CubeG4/blob/21b2f2fa52ef813c38285abb6b04636910d367c9/Release_Notes.html#L133-L137
But I…
-
I'm trying to start a embassy project for a STM32G4 microcontroller from scratch, but i'm facing an persistent error.
When i try to compile with cargo build or cargo embed i'm getting the following e…
-
**What are you doing?**
使用EIDE构建STM32G4工程
**Describe the bug**
设置好GCC编译配置后切换到ARMC编译,再切换回GCC,链接脚本路径选项又回到了初始值
这个配置应该可以像{project}.arm.options.gcc.json一样保存,方便调试
**To Reproduce**
Steps to reprodu…
dukmu updated
6 months ago
-
Replacing `opt-level = 0` with `opt-level = 0` or `opt-level = "s"` causes adc conversion to get stuck at `wait_for_conversion_sequence`. As far as I can see the same thing happens when running in rel…
-
I bought a MIT compatible motor which could run directly on https://github.com/bgkatz/motorcontrol.
I think moteus use the same chips such as 5027p, drv8323, stm32.
Can i just modify some pin d…
-
Hi,
How to set
hspi1.Init.MasterKeepIOState = SPI_MASTER_KEEP_IO_STATE_ENABLE; parameter in STM32G4 for SPI communication in Poll for conversion method.Its giving me error If I add this in MX_SPI1…