-
I would really appreciate some help here, cause I am stuck for almost a week now. I have a brand new F405 wing and an L9R receiver. For some reason I get no sbus signal from the L9R to the FC. The rec…
-
Howdy,
What are your thoughts on adding a basic OSD menu system to change settings using the ele/pitch sticks similar to what is found on a Eagle Tree Vector.
See this video at 9mins 51s to see …
-
Hello,
I crashed with my flying wing in a very strange way since I installed a PDB Matek FCHUB-W and FC F722 STD under INAV 2.0 RC6.
The first flight went smoothly but during the second flight, I fe…
-
Dear All Friend,
I have problem about Setup Inav for Glider Plane. i use CC3D board with PWM rx (frsky V8R II). curently i'm not use gps so the nav_extra_arming_safety = OFF. When arming mode selec…
-
My today's FPV experience:
I took off from a spot 280 meters AMSL (altitude above mean sea level)
I was remotely landing the plane while in the stabilized mode at an RC field that was a 1000 meters…
JeyPi updated
6 years ago
-
Configurator 1.9.3
Loading preset for 600mm flying wing does not change PiD tuning page Roll Rate and Pitch Rate on iNav 1.9.1.
The code
presets.elementHelper("RC_tuning", "roll_rate…
-
Quick note.
It is not possibile, when choosing to run ASYNC (ALL/GYRO), to select a sample frequency that is not 8K for the gyro.
INAV 2.0.0RC4 both F3/F4
-
### If your issue looks like a hardware fault or a configuration problem please don't raise an issue here.
I don't believe so. I've spent a long time checking radio and servo settings. I may be con…
-
#### Reversed YAW
Differential spoilers (@ AUX9 and AUX10) have been setup on Flying wing .
Can obtain correct YAW movement with RC, however autopilot recognizes opposite YAW movement (arming requi…
-
Not sure whats causing it yet. Going to put the wing back in the air and then check the sensor list to see whats causing the alarm. I will post the logs once I pull them.